Paxar Monarch TC6039SA - Manual (Page 52)

5-14 System Administrator’s Guide
Configuring Codabar Bar Codes
1. To configure Codabar settings, tap Codabar from the Scanner
Configuration screen.
2. Enable each bar code you need to scan.
Codabar Allows the scanner to scan
Codabar bar codes.
NOTISEdit Tells the scanner to strip the
start and stop characters from
scanned Codabar bar codes.
CLSIEdit Tells the scanner to strip the
start and stop characters from
14-character Codabar bar codes
and insert spaces after the first,
fifth, and tenth characters.
Note: The 14-character length
does not include start and
stop characters.
Lengths
Sets the
length(s)
for
Codabar
bar codes. Variable, specifies that Codabar bar codes can be any
length.
Note: Specifying a range of lengths increases the likelihood
of unsuccessful scans.
1 Fixed, specifies a single length for valid Codabar bar
codes. The range for Length 1 is 1 – 99. The default is 5.
2 Fixed, specifies two lengths for valid Codabar bar codes.
The range for Length 2 is 1 – 99. The default is 55.
3. Tap OK to save all the settings and return to the Scanner
Configuration screen.