Configuring the unit using the internal switches – Paradyne Hotwire 7975 User Manual

Page 32

Advertising

Initial Startup and Configuration

3-6

7975-A2-GB20-40

December 1998

Configuring the Unit Using the Internal Switches

Use internal Switchpacks S1 and S2 to manually configure the unit. Use
Figure 3-1 to locate Switchpacks S1 and S2.

HANDLING PRECAUTIONS FOR
STATIC-SENSITIVE DEVICES

This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.

Procedure

To configure the unit using internal Switchpacks S1 and S2:

1. Power down the unit and remove the enclosure cover, exposing the circuit

board.

2. Locate Switchpack S1 using Figure 3-1.

3. Set switch 1 on Switchpack S1 to ON to enable Switchpacks 1 and 2.

4. After you enable the switchpacks, you must set the switches to your desired

configuration. Refer to

Figure 3-1

and

Table 3-1

5. Replace and secure the cover.