Paradyne Hotwire 7975 - Manual (Page 95)

Configuration Option Tables
A-15 7975-A2-GB20-40 December 1998
Table A-7. SNMP Traps Options (2 of 2)
Enterprise Specific Traps
Possible Settings: Enable, Disable
Default Setting: Disable
Determines if SNMP traps are generated for enterprise-specific events.
Enable – SNMP traps are generated for enterpriseSpecific events.
NOTE: Refer to Enterprise Specific Traps in Appendix B, Standards Compliance
for SNMP Traps .
Disable – No enterprise-specific event traps are sent.
Link Traps
Possible Settings: Disable, Up, Down, Both
Default Setting: Both
Determines if SNMP traps are generated for link up and link down for one of the
communication interfaces.
Disable – No linkUp or linkDown SNMP traps are generated.
Up – A linkUp trap is generated when the 7975 Termination Unit recognizes that one of
the communication interfaces is operational.
Down – A linkDown trap is generated when the 7975 Termination Unit recognizes a
failure in one of the communication interfaces.
Both – Sends trap messages for detection of both linkUp and linkDown.
NOTE: Refer to linkUp and linkDown in Appendix B, Standards Compliance for
SNMP Traps.
Link Trap Interfaces
Possible Settings: Network, SYNC, All
Default Setting: All
Determines if the SNMP linkUp, SNMP linkDown, and interface-related
enterpriseSpecific traps are generated for the network interface and synchronous data
(DTE) port, or all.
Network – SNMP trap messages are generated for the network interface.
SYNC – SNMP trap messages are generated for the synchronous data (DTE) port.
All – SNMP trap messages are generated for the network interface and the
synchronous data (DTE) ports.