Paradyne Hotwire 7975 - Manual (Page 97)

Configuration Option Tables
A-17 7975-A2-GB20-40 December 1998
SNMP NMS Security Options
SNMP configuration options allow you to specify the information necessary to
support the Termination Unit SNMP NMS Security. To access the SNMP NMS
Security Options screen, follow this menu selection sequence:
Main Menu
→
Configuration
→
Load Configuration From
→
Edit
→
Management and Communication
→
SNMP
→
Security
Table A-9. SNMP NMS Security Options
NMS IP Validation
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether security checking is performed on the IP address of SNMP
management systems attempting to access the node.
Enable – Security checking is performed on the IP address of SNMP management
systems attempting to access the node.
Disable – No security checking is performed.
Number of Managers
Possible Settings: 1, 2, 3, 4, 5
Default Setting: 1
Specifies the number of SNMP management systems that can send SNMP messages.
1 to 5 – Number of trap managers. An NMS IP address is required for each manager.
NMS n IP Address
Possible Settings: 000.000.000.000 – 223.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the Internet Protocol address used to identify each SNMP manager.
000.000.000.000 – 223.255.255.255 – Enter an address for each SNMP manager. The
range for the first byte is 000 to 223, with the exception of 127. The range for the
remaining three bytes is 000 to 255.
Clear – Clears the IP address and sets to all zeros.
Access Level
Possible Settings: Read, Read/Write
Default Setting: Read
Determines the access level allowed for an authorized NMS when IP address validation
is being performed.
Read – Allows read-only access (get) to the accessible objects in the MIB for this
device.
Read/Write – Allows read/write access (get/set) to the accessible objects in the MIB for
this device.