Paradyne Hotwire 7975 - Manual (Page 83)

Configuration Option Tables
A-3 7975-A2-GB20-40 December 1998
Table A-1. Network Interface Options (2 of 2)
DSL Line Rate
Possible Settings: 144, 272, 400, 528, 784, 1040, 1552 (2 Mbps unit only),
2064 (2 Mbps unit only)
Default Setting: 144
Specifies the DSL line rate of the unit. This option is only available when the standalone
unit is configured as an LTU and AutoRate is disabled (unit is in fixed rate).
144 – Available payload rates are: 64 and 128 kbps.
272 – Available payload rates are: 192 and 256 kbps.
400 – Available payload rates are: 320 and 384 kbps.
528 – Available payload rates are: 448 and 512 kbps.
784 – Available payload rates are: 576, 640, 704, and 768 kbps.
1040 – Available payload rates are: 832, 896, 960, and 1024 kbps.
1552 (2 Mbps unit only) – Available payload rates are: 1088, 1152, 1216, 1280, 1344,
1408, 1472, and 1536 kbps.
2064 (2 Mbps unit only) – Available payload rates are: 1600, 1664, 1728, 1792, 1856,
1920, 1984, and 2048 kbps.
Peer IP Address
Possible Settings: 000.000.000.001 – 223.255.255.255, Clear
Default Setting: 000.000.000.001
Specifies the peer IP address for the remote management providing the remote
management link on the DSL loop. This option is only available when the standalone
unit is configured as an LTU.
000.000.000.001 – 223.255.255.255 – Enter an address for the peer unit. The range for
the first byte is 000 to 223, with the exception of 127. The range for the remaining three
bytes is 000 to 255. The peer IP address must be in the same subnet as the MCC
address.
Clear – Clears the IP address field and sets to all zeros.
Circuit Identifier
Possible Settings: [ASCII Text], Clear
Default Setting: [blank]
Uniquely identifies the circuit number of the transmission vendor’s DSL line for
troubleshooting purposes.
[ASCII Text] – Enter a maximum of 128 characters. All printable ASCII characters
except ^ (caret) are allowed.
Clear – Clears the field.