Panasonic WJ-NT104 - Manual (Page 34)

34
● Fixed Input Selection Mode
q PRESET SELECT
To move the combination camera (option) connected to
the WJ-NT104 to any of 8 preset position numbers.
To register preset positions refer to the CAMERA
MENU SETUP on page 53.
w ALARM LIST
Camera video input before and after alarm input can
be temporarily stored in the internal memory of the WJ-
NT104.
For alarm display see ALARM LIST on page 37.
e Live image display
Images from the cameras connected to the WJ-NT104
are displayed.
Note: Other than the camera of the channel set cannot
be selected.
r Pan/Tilt
Clicking anywhere on the live image moves the con-
nected combination camera (option) up and down, or
to the right and left. The camera pan/tilt angle
decreases as the point clicked moves closer to the
image center. Clicking the image center will not move
the camera. Zooming does not change the camera
pan/tilt angle. Click the image repeatedly to move the
camera to the desired position. You cannot pan or tilt
the camera continuously by dragging on the live
image.
t ZOOM
The connected combination camera (option) can be
zoomed by clicking the
[TELE] or [WIDE] button under
ZOOM.
Clicking the
[TELE] or [WIDE] button will operate the
camera in telescopic or wide-angle mode for a speci-
fied time, after which the mode is released automatical-
ly. These modes cannot be retained by keeping the
[TELE] or [WIDE] button depressed. You need to click
the [TELE] or [WIDE] button again.
y FOCUS
The connected combination camera (option) can be
focused by clicking the
[FAR] , [NEAR] or [AUTO] but-
ton under FOCUS.
Clicking the
[FAR] or [NEAR] button will operate the
camera in focusing mode for a specified time, after
which the mode is released automatically. Clicking the
[AUTO] button will automatically focus the video on the
screen. Focus control cannot be retained by keeping
the
[FAR] or [NEAR] button depressed. You need to
click the [FAR] or [NEAR] button again.
q
w
e
o
r
i
u
y
t