Panasonic WJ-NT104 User Manual
Page 36
36
u
ZOOM
The connected combination camera (option) can be
zoomed by clicking the
[TELE]
or
[WIDE]
button under
ZOOM.
Clicking the
[TELE]
or
[WIDE]
button will operate the
camera in telescopic or wide-angle mode for a speci-
fied time, after which the mode is released automatical-
ly. These modes cannot be retained by keeping the
[TELE]
or
[WIDE]
button depressed. You need to click
the
[TELE]
or
[WIDE]
button again.
i
FOCUS
The connected combination camera (option) can be
focused by clicking the
[FAR]
,
[NEAR]
or
[AUTO]
but-
ton under FOCUS.
Clicking the
[FAR]
or
[NEAR]
button will operate the
camera in focusing mode for a specified time, after
which the mode is released automatically. Clicking the
[AUTO]
button will automatically focus the video on the
screen. Focus control cannot be retained by keeping
the
[FAR]
or
[NEAR]
button depressed. You need to
click the
[FAR]
or
[NEAR]
button again.
o
IRIS
The connected combination camera (option) can be
controlled to close or open the iris by clicking the
[OPEN]
or
[CLOSE]
button under IRIS. Clicking the
[OPEN]
or
[CLOSE]
button will open or close the cam-
era iris for a specified time, after which the operation is
released automatically.
Clicking the
[RESET]
button on the screen will reset
the iris of the displayed camera to the factory default
setting. Iris control cannot be retained by keeping the
[OPEN]
or
[CLOSE]
button depressed. You need to
click the
[OPEN]
or
[CLOSE]
button again.
!0
AUTOPAN
The auto pan status of the connected combination
camera (option) can be changed by clicking the
[ON]
or
[OFF]
button under AUTOPAN.
Note:
When LOCAL is selected in the camera setup,
AUTOPAN automatically stops after 1 minute.
When REMOTE is selected in the camera setup,
AUTOPAN will not stop automatically.
!1
PRESET
To move the connected combination camera (option) to
any of 64 preset positions. Select a preset position
number, then press the
[SET]
button to move the cam-
era to the position.