Paradyne 3510 - Manual (Page 49)

Installation
4-9 3510-A2-GN32-60 March 1999
Connecting to a V.35 Interface
To connect a V.35 interface cable:
"
Procedure
1. Connect the 25-pin end of the V.35 adapter to the
bottom DTE connector on the rear connector plate
(refer to Figure 4-5). Tighten the thumbscrews on
both sides of the connector.
2. Connect the 34-pin end of the V.35 adapter to the
DTE’s V.35 interface cable. Tighten the screws on
both sides of the connector.
Installation of the V.35 interface cable is complete.
NOTE
For the V.35 connector, the
recommended maximum distance
between a DTE and a DSU is
nominally 1000 feet. For the
EIA-232 connector, the effective
shunt capacitance of the circuit,
measured at the DSU, including
the capacitance of the cable and
the DTE, must not exceed
2500 picofarads, as specified
in EIA-232-D.
25-Pin Connector
V.35 Adapter
V.35 Cable
Thumbscrews
99-16298
Figure 4-5. Model 3511 DSU V.35 Adapter Installation
(Feature Number 3000-F1-510)