Paradyne 3510 - Manual (Page 5)

Safety Instructions
D 3510-A2-GN32-60 March 1999
Government Requirements
The Federal Communications Commission (FCC) requires that instructions pertaining to
connection to the telephone network be included in the installation and operation manual. Specific
instructions are listed in this section.
Notice to Users of the Digital Data Service
This equipment complies with Part 68 of the FCC rules. On the bottom of the equipment is a label
that contains, among other information, the FCC registration number for this equipment. If
requested, please provide this information to your telephone company.
If your DSU causes harm to the telephone network, the telephone company may discontinue your
service temporarily. If possible, they will notify you in advance. But if advance notice is not
practical, you will be notified as soon as possible. You will be advised of your right to file a
complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations, or procedures
that could affect the proper operation of your equipment. If so, you will be given advance notice so
as to give you an opportunity to maintain uninterrupted service.
No repairs may be performed by the user. Should you experience difficulty with this equipment,
refer to the
Equipment Warranty and Support section of Chapter 1.
For Digital Data Service (DDS) installations, inform the local telephone company of the
appropriate network channel interface code for the service you desire.
DDS
Interface
Code
Data Rate
(bps)
04DU5-24 2400
04DU5-48 4800
04DU5-96 9600
04DU5-19 19,200
04DU5-56 56,000
04DU5-64 64,000
The DDS Service Order Number is 6.0Y. The jack configurations required are RJ48S for the
Model 3510 DSU and RJ48T for the Model 3511. With an RJ48T configuration, you must specify
the number of data lines you require (1 through 8 ).
After the telephone company has installed the requested jack, you can connect the DSU with the
appropriate cable (provided). An FCC-compliant telephone cord and modular plug is provided
with this equipment. This equipment is designed to be connected to the telephone network or
premises wiring using a compatible modular jack that is Part 68 compliant.