Panasonic AJ-D750P - Manual (Page 49)

Setup menus
USER menu
<EDIT>
Item
No.
Superimposed
display
3 0 0 VAR
RANGE
301 IN/OUT
DEL
302 NEGA
FLASH
303 STD/
NON-STD
304 SERVO
REF
305 EDIT
RPLCE1
Setting
No.
Superimposed
0000
0001
0000
0001
display
– 0.43 – 1
–4–+4
Description
This sets the VAR speed range.
0:
The tape is played in slow motion at a speed ranging from
– 0.43 × to +1 × (or from – 0.5 × to +1 × for the DV
format) normal speed.
0000
0001
0000
0001
0002
0000
0001
0000
0001
0002
0003
MANU
AUTO
OFF
ON
AUTO
STD
N-STD
AUTO
EXT
N-DEF
CH1
CH2
CH1+2
1: The tape is played in the ±4.1 × normal speed range.
<Note>
Phase synchronization from the editing controller is no longer
possible once this item has been set to “0”.
For DV format:
When using the dial on the front panel, playback is always
performed at – 0.5 to +1 × normal speed regardless of the
menu setting.
When using the 9P (RS-232C), when 0 is selected, playback is
performed at – 0.5 to +1
× normal speed.
When 1 is selected, playback is performed at – 3.1 to +3.1 ×
normal speed.
This selects the operation to be performed when an edit point
has been set incorrectly (when the OUT point is before the IN
point).
0: Editing is not executed unless the illegal edit point is
cleared or set again properly.
1: The edit points already input are automatically cleared.
This selects whether to show a negative display when the IN
point is greater than the OUT point.
0: No negative display.
1: Negative display.
This selects STD or NON-STD in accordance with the
composite input signal..
0: Standard/non-standard signals are automatically identified
and processed.
1: Standard signals are processed. (Forced STD)
2: Non-standard signals are processed. (Forced NON-STD)
This selects the video signal processing.
0: Servo is synchronized with the input signal during recording
and editing, or with the REF signal during playback.
1: Servo is synchronized at all times with the REF signal.
This sets the channel assignments for the controller’s analog
audio preset when editing the digital audio of the VTR using a
controller which does not have a digital audio edit preset
control function.
This selects the channel concerned when the VTR CH1 edit
preset is set in compliance with the ON or OFF presetting for
the analog audio signals designated by the controller.
0: Not set.
1: Compliance with analog CH1 edit preset.
2: Compliance with analog CH2 edit preset.
3: Compliance with either analog CH1 or CH2 edit preset.
The underline on the setting item denotes the initial setting.
- 4 9 -