Panasonic AJ-D750P - Manual (Page 52)

USER menu
<TIME CODE>
Item Setting
No.
Superimposed
No.
Superimposed
display display
500 VITC
POS-1
501 VITC
POS-2
502 VITC
BLANK
5 0 3 TCG
REGEN
5 0 4 REGEN
MODE
5 0 5 E X T T C 0000
SEL 0001
0000 10L
0001 11L
0002 12L
0003 13L
0004 14L
0005 15L
0006 16L
0007 17L
0008 18L
0009 19L
0010 20L
0000 10L
0001 11L
0002 12L
0003 13L
0004 14L
0005 15L
0006 16L
0007 17L
0008 18L
0009 19L
0010 20L
0000 BLANK
0001 THRU
0000 TC&UB
0001 TC
0002 UB
0000 AS&IN
0001 ASSEM
0002 INSRT
0003 SW
LTC
VITC
Description
This sets the position where the VITC signal is to be inserted.
(The same line as for VITC POS-2 in 501 cannot be
selected.)
This sets the position where the VITC signal is to be inserted.
(The same line as for VITC POS-1 in 500 cannot be
selected.)
This selects whether to output the VITC data to the positions
selected by VITC POS-1 in 500 and VITC POS-2 in 501.
0: Data is not output.
1: Data is output.
This selects the signal to be regenerated when the time code
generator (TCG) in the REGEN mode.
0: Both the time code and user bit are regenerated.
1: Only the time code is regenerated.
2: Only the user bit is regenerated.
This selects whether the time code is to be regenerated
during automatic editing using the unit’s control panel.
0: Time code is regenerated with assemble or insert editing.
1: Time code is regenerated with assemble editing.
2: Time code is regenerated with insert editing.
3: Setting complies with REGEN/PRESET switch setting.
This selects the time code to be used when an external time
code is to be used.
0: The LTC of the TIME CODE IN connector is used.
1: The video signal LITC is used.
The underline on the setting item denotes the initial setting.
- 5 2 -