Panasonic AJ-D750P - Manual (Page 68)

Connector signals
PARALLEL REMOTE (25P)
Pin No. Signal Pin No. Signal
1 PLAY COMMAND 10
2 STOP COMMAND 11
3 FF COMMAND 12 > 10V, MAX 300mA
4 REW COMMAND 13 PLAY STATUS
5 REC COMMAND 14 STOP STATUS
6 EJECT COMMAND 15 FF STATUS
7 STANDBYON/OFFCOMMAND 16 REW STATUS
8 PREROLL COMMAND 17 REC STATUS
9 IN SET COMMAND 18 EJECT STATUS
<Notes>
Pin No. Signal
19 STAND BY ON STATUS
20 PREROLL STATUS
21 SERVO LOCK STATUS
22
23
24
25 GND
COMMAND pins: TTL level, active low, 100ms edge electrical signal.
STATUS pins: open collector, sink current 6mA
RS-232C REMOTE (25-pin D-SUB crossover cable supported)
Pin No. Abbreviation Circuit Description
1 FRAME GROUND Protective ground Frame ground
2 RxD Received data Sends data to the PC.
3 TxD Transmitted data Receives data from the PC.
4 CTS Clear to send Shorted with pin 5.
5 RTS Request to send Shorted with pin 4.
6 DTR Data terminal ready No processing
7 GND Signal ground Signal ground
20 DSR Data set ready
Positive power output after communication enable
status
Example of connections with controller (PC) using a 25-pin D-SUB crossover cable
PC end (D-SUB 25 pins) VTR end (D-SUB 25 pins)
FG 1
TxD 2
RxD 3
RTS 4
CTS 5
DSR 6
GND 7
DTR 20
1 FG
2 RxD
3 TxD
4 CTS
5 RTS
6 DTR
7 GND
20 DSR
ENCODER REMOTE (15P)
Pin No. Signal Pin No. Signal Pin No. Signal
1 6 SYSTEM H 0 11 RET GND
2 SET UP 7 SYS.SC COARSE (2) 12
3 C LEVEL 8 –12V 13
4 GND 9 HUE 14 SYS.SC FINE
5 +12V 10 VIDEO LEVEL 15 SYS.SC COARSE (1)
- 68 -
>
=