Printronix P9000 Series - Manual (Page 20)

Operation 2-2
You can also define and download an international language to allow any character within the
character library to be substituted for any code. Similarly, an individual character in a font, or
an entire set of characters, can be created and placed in a font. These downloading features are
discussed in more detail in the Programming chapter and the Appendix.
Power Switch
The AC power switch is located at the lower left corner of the rear panel of the printer. To turn
the printer power on, set the power switch to the ON (|) position.
- WARNING -
The power cord requires an IEC (hot) connector to mate to the receptacle on the rear
panel of the printer. The hot connector includes a polarizing key which prevents the
use of cordsets that are not of the correct rating for the printer.
- WARNUNG -
Das Stromkabel benötigt einen IEC (spannungsführenden) Stecker, der in die
Steckdose an der hinteren Wand des Druckers passt. Der spannungsführende
Stecker kommt mit einem Nulleiter, der die Benutzung von Stromkabeln ohne die
korrekte Nennleistung für den Drucker verhindert.
The Control Panel
The printer control panel is illustrated in Figure 2-1. Each component of the control panel is
discussed on the following pages.
Status Lamps
The status lamps are lit continuously when the printer is on line to the host and are off when the
printer is off line. The lamps flash alternately if a fault condition exists in the printer.
Alphanumeric Message Display
The message display shows printer status and fault condition messages. During normal operaĆ
tion, the display indicates the on line status and the current print mode (and pitch) selection.