Printronix P9000 Series - Manual (Page 233)

11-3 Installation
Figure 11-1. Site Requirements
Shipping Restraints
During shipping, the printer mechanism is protected by foam packing and removable tie wraps
which secure the Forms Thickness Adjustment Lever, Paper Guide, Front Paper Fence, and
Paper Tent. Remove the foam packing and tie wrap restraints as described below, referring to
Figure 11-2.
- WARNING -
To prevent possible injury, do not connect the AC power source before removing the
shipping restraints. If the power source has already been connected, disconnect it
before performing the shipping restraint removal procedures.
- WARNUNG -
Um mögliche Verletzungen zu vermeiden, darf die Netzverbindung erst nach dem
Entfernen der Transportbefestigungen hergestellt werden.
Shipping Restraint Removal
1. Swing open the left and right tractor gates (A) and remove the foam pad from the paper
path in front of the platen.
2. Using the press-release tabs, remove the tie-wrap restraints:
a.
Securing the Forms Thickness Adjustment Lever (B).
b. Securing the Paper Guide (C).
c. Open the rear printer door and remove the tie-wraps securing the Front Paper
Fence (D) to the cabinet frame.
d. Securing the Paper Tent (E) to the Front Paper Fence (D).