Setting forms length – Printronix P9000 Series User Manual
Page 34
Operation
2-16
Setting Forms Length
NOTE: Forms length can also be set by control code from the host computer which will
override the control panel setting. Using control codes, the host computer can specify
forms lengths other than those available from the control panel. Refer to the ProgramĆ
ming chapter for more information.
The printer uses continuous, tractor-fed paper with the forms length set between 1.0 and 24.0
inches, or between 1 and 192 lines at 6 or 8 lines per inch. Setting the forms length in lines at 6 or
8 lpi does not change the line spacing.
The printer has been preset for 11-inch length paper. When using paper of a different length,
the top-of-form setting and the forms length setting must be changed to match the desigĆ
nated length. To set the forms length:
1.
Place the printer off line and raise the printer cover.
2.
Simultaneously press MENU UP and MENU DOWN to unlock the printer configuraĆ
tion. ENTER SWITCH NOT LOCKED will be displayed briefly.
3.
Press F/L; the display will show FORMS LENGTH SET IN INCHES.
4.
Press NEXT or PREV to cycle through the following options: FORMS LENGTH SET IN
6 LPI LINES, FORMS LENGTH SET IN 8 LPI LINES, and FORMS LENGTH SET IN
INCHES. Select an option, and perform the corresponding instructions below.
To Set Forms Length in Inches
1.
Press NEXT or PREV until FORMS LENGTH SET IN INCHES is displayed.
2.
Press MENU DOWN or F/L to display the current forms length in inches.
3.
Press NEXT or F/L to increase the forms length in 0.5-inch increments, or press PREV
to decrease the forms length in 0.5-inch increments. When the appropriate value is disĆ
played, save it as described below.
4.
Press ENTER to select the displayed forms length.
5.
Press CLEAR to return to OFFLINE READY.
6.
Simultaneously press MENU UP and MENU DOWN to lock the printer configuration.
7.
Set the top of form according the the instructions on page 2-9.
8.
Close printer cover and place the printer on line.
To Set Forms Length in Lines
1.
Press NEXT or PREV until FORMS LENGTH SET IN 6 LPI LINES or FORMS
LENGTH SET IN 8 LPI LINES is displayed.