Palm 680 - Manual (Page 17)

S E T T I N G U P
11
1
CH
AP
T
E
R
replacement batteries, see Replacing the
battery.
7 Slide the battery door onto the back of
the Treo 680 until it clicks into place.
8 Your Treo screen wakes up and begins
the setup process. When the language
selection screen appears, select the
language you want to use, and then
follow the onscreen instructions to set
up your Treo.
IMPORTANT Always use the same
language for your Treo, your computer
operating system, and your desktop
software. Otherwise, you may lose
information or have difficulty with
synchronization. Support is not provided for
mismatched language setups.
Charging the battery
The battery comes with a sufficient charge
to complete the setup process and activate
your phone. After activation, we
recommend charging your Treo 680 for
three hours (or until the indicator light is
solid green) to give it a full charge. See
Maximizing battery life for tips on
maximizing the life of your Treo battery.
TIP If your Treo does not turn on, you need to
connect it to the AC charger. If it still does not
turn on after being connected to the AC
charger for five minutes, then do a soft reset.
See Performing a soft reset.
TIP The power-saving feature turns off the Treo
screen after a period of inactivity. To wake up
the screen, press and release Power/End,
and then press Center on the 5-way to turn off
Keyguard.
TIP To avoid draining the battery, charge your
Treo 680 every day, especially if you use your
phone often.
DID YOU KNOW ? If your battery ever becomes
fully drained, your info is still stored safely on
your Treo 680 until you recharge the battery or
connect your Treo 680 to a power source.