Philips KX-TAW848 - Manual (Page 69)

2.7 Connection of 2.4 GHz Portable Stations
Installation Manual 69
2.7 Connection of 2.4 GHz Portable Stations
2.7.1 Overview
The following equipment is required to connect the wireless system:
CS: Cell Station (KX-T0141)
This unit determines the area covered by the wireless system. Up to 2 calls can be made at the same time
through each CS.
PS: 2.4 GHz Portable Station (KX-TD7680/KX-TD7690)
The KX-TAW848 can support up to 28 PSs. For more details about the PS, refer to the PS Operating
Instructions.
CAUTION
• The CS should be kept free of dust, moisture, high temperature (more than 40 °C [104 °F]), low
temperature (less than 0 °C [32 °F]), vibration, and should not be exposed to direct sunlight.
• The CS should not be placed outdoors (use indoors).
• The CS should not be placed near high voltage equipment.
• The CS should not be placed on a metal object.
• Systems using 2.4 GHz ISM (Industrial, Scientific and Medical) band may interfere with the
wireless system. Examples of such systems are cordless telephones, wireless LAN, Home RF,
microwave ovens and other ISM devices. These systems may cause minor noise.
• Keeping some distance between the equipment listed below may prevent interference. (The
distance may vary depending on the environment.)
Equipment Distance
CS and office equipment such as a computer, telex, fax
machine, etc. More than 2 m (6 ft 7 in)
CS and PS More than 1 m (3 ft 3 in)
Each PS More than 0.5 m (1 ft 8 in)
PBX and CS More than 2 m (6 ft 7 in)
CS and CS More than 15 m (49 ft)
Please take into consideration the distance between the CSs when site planning. Please consult
your dealer for details.
However, the required distance between CSs may vary depending on the environment of the
installation site and conditions in which the wireless system is used. Conduct the site survey to
determine the appropriate distance.