Printronix P7000 H-Series - Manual (Page 22)

22
Chapter 2 The Configuration Menu
CPI/LPI Select
This parameter lets you specify the characters per inch (cpi) and lines per
inch (lpi) values. The defaults are:
• Select CPI - 10.0 cpi
• Select LPI - 6.0 lpi
• DBCS CPI - 6.0 cpi
Host Command
• Enable. The default. Enables all host printing commands.
• Ignore All. This function treats all control codes and printing commands
as the data.
• Ignore CPI. This function ignores the CPI selection commands only
(e.g., ESC M, ESC P, and ESC G).
• Ignore LPI. This function ignores the LPI selection commands only
(e.g., ESC 2 and ESC 0).
• Ignore Unidir. All unidirectional commands sent by the host are ignored
by the printer.
• Ignore Pg. Fmt. This function ignores all page format setting commands
sent from the host.
Margins Perforation
Skip
Form Length Form Width
Left Margin
0* columns
(0-369)
Right Margin
0* columns
(0-369)
Bottom Margin
0* lines
(0-451)
Disable*
1/2 inch
2/3 inch
5/6 inch
1 inch Abs. Length IN
11.0* inches
(0.1-24)
Abs. Length MM
279.4* mm
(0.1-609.6)
Funct. of Lines
66* lines
(1-192)
Abs. Width IN
13.6* inches
(0.1-13.6)
Abs. Width MM
345.4* millimeters
(0.1-345.4)
Funct. of CPI
163* Characters
(1-272)
Page Format
(from the
previous page)