Printronix P7000 H-Series - Manual (Page 61)

Select Double-width Printing in DBCS Mode (One
61
Select Double-width Printing in DBCS Mode
(One Line)
ASCII Code FS SO
Hex Code 1C 0E
Dec Code 28 14
Purpose Doubles the width of all characters, spaces, and intercharacter
spacing (set with the FS S or FS T commands) on the same
line as the command.
Comment This command is cancelled when the printer receives the
following commands: LF, FF, VT, DC4, FS W 0, and CR.
This command can be cancelled by FS W 0 and FS !
This command works under ASCII mode, and it works the
same as the SO or ESC SO commands.
The default is Normal (non double-width) printing.
Cancel Double-width Printing in DBCS Mode
(One Line)
ASCII Code FS DC4
Hex Code 28 14
Dec Code 1C 20
Purpose Cancels double-width printing selected by the FS SO
command.
Comment This command does not cancel double-width printing selected
by the FS W command.
The default is Normal (non double-width) printing.