Printronix P7000 H-Series - Manual (Page 49)

Master Select One-Line Attribute In DBCS Mode
49
Master Select One-Line Attribute In DBCS Mode
ASCII Code ASSC 0 ! n
Hex Code ASSC 30 21 n
Dec Code ASSC 48 33 n
Purpose Where:
0 < =
n < = 255
Select any combination of several one-line attributes by setting
or clearing the appropriate bit in the n parameter, as show in
the table below.
Comment These attributes are canceled when the printer receives the
following commands: LF, FF, VT, and CR.
This command takes effect only in DBCS mode.
Pair Two Characters in Vertical Printing
ASCII Code FS D d
1
d
2
Hex Code 1C 44 d
1
d
2
Dec Code 28 68 d
1
d
2
Purpose Aligns two rotated characters to fit the space occupied by a
normal size rotated character where
d
1
is the lower character
and d
2
is the upper character. Both d
1
and d
2
can be SBCS
characters or DBCS characters. If the character is a DBCS
character, it will automatically be half-width.
Comment This command has an effect only in vertical printing mode.
Only two characters are combined at a time.
Bit On/Off Hex Dec Function
2 Off
On 00
04 0
4 Cancel double width
Select double width
3 Off
On 00
08 0
8 Cancel double height
Select double height