Printronix P7000 H-Series - Manual (Page 77)

Turn Double-Width, Double-Height Printing On/Off
77
Turn Double-Width, Double-Height Printing On/Off
ASCII Code FS W n
Hex Code 28 57 n
Dec Code 1C 87 n
Purpose Turns on/off double-width, double height printing of all
characters, spaces, and intercharacter spacing (set with the
FS S or FS T commands) on the same line as this command,
as follows:
n = 0 or 48Turns off double-width double-height
n = 1 or 49Turns on double-width double-height
Where:
n = 0, 1, 48, 49
Comment The baseline of the line including double-width, double-height
characters moves down 24/180 inch, and the line spacing also
increases 24/180 inch.
The default is Normal (non double-width double-height)
printing.
Turn Double-Width Printing On/Off
ASCII Code ESC W n
Hex Code 1B 57 n
Dec Code 27 87 n
Purpose Turns on/off double-width printing of all characters, spaces, and
intercharacter spacing (set with the ESC SP command)
following this command as follows:
n = 1 or 49Turns on double-width
n = 0 or 48Turns off double-width
Comment This command works under both ASCII and Hangul modes.
The default is Normal (non double-width) printing.