Panasonic MINAS A4P Series - Manual (Page 101)

101
[Setting]
Setting
<Remarks>
Don't disconnect the console from the driver between to .
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.
<Note>
If the error display repeats frequently, check the broken cable, disconnection of the connector,
misoperation due to noise or failure of console.
Initialization of EEPROM
of the console starts.
Copying completes normally.
Error display
To move to the next process, press .
The positioning parameter is copied
from the servo driver into the
console and the positioning
parameter is written into EEPROM
(console).
The servo parameter and driver
type code are copied from the servo
driver into the console and the
driver type code of the servo
parameter is written into EEPROM
(console).
<Remarks>
If error is displayed, repeat
the procedures from the
beginning.
Press for releasing error.
Starting from initial LED status, Press six time after pressing , then press ,
to make a display to
Press to call for
EXECUTION DISPLAY of
Keep pressing until
the console display (LED)
changes to .
“ ” increases by
pressing (approx. 3sec)
as the left fig. shows.
SELECTION display When you have finished the copy, press to return to .
Copying Function (Console Only)
Copying of Parameters from the Driver to the Console
Operation at SELECTION display
Operation at EXECUTION display