Panasonic KX-FC225NZ User Manual
Page 65
12. Help
65
I have changed the cordless
handset display language to a
language I cannot read.
L
Change the cordless handset display language (page 54).
w
is flashing.
L
The cordless handset is not registered to the base unit. Register it (page
55).
L
The cordless handset is too far from the base unit. Move closer.
L
The power cord is not connected. Check the connections.
L
You are using the cordless handset or base unit in an area with high
electrical interference. Locate the cordless handset and base unit away
from interference sources, such as antenna and mobile phones.
The cordless handset does
not ring.
L
The ringer volume is turned OFF. Adjust it (page 18).
The batteries should be
charging but the battery icon
does not change.
L
Clean the charge contacts and charge again (page 17).
A busy tone is heard when
{C}
is pressed.
L
The cordless handset is too far from the base unit. Move closer and try
again.
L
The base unit or another cordless handset is on an outside call. Wait for the
other user to complete the call.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
L
Place the cordless handset and the base unit away from other electrical
appliances.
L
Move closer to the base unit.
L
For Australian users:
Your unit is connected to a telephone line with ADSL service. We
recommend connecting a filter (contact your ADSL service provider) to the
telephone line between the base unit and the telephone line jack.
For New Zealand users:
Your unit is connected to a telephone line with ADSL (JetStream) service.
We recommend that you contact your ADSL service provider to have an
ADSL Splitter installed. We do not recommend the use of generic ADSL
filters.
Noise is heard during a call.
L
You are using the cordless handset or base unit in an area with high
electrical interference. Place the cordless handset and base unit away from
interference sources, such as antennas and mobile phones.
The cordless handset stops
working while being used.
L
Disconnect the mains lead and turn OFF the cordless handset to reset the
unit. Connect the mains lead, turn ON the cordless handset and try again.
I cannot redial by pressing
{R}
.
L
If the redialled number was more than 24 digits long, the number will not be
redialled. Redial the number manually.
7
flashes or the cordless
handset beeps intermittently
while it is in use.
L
Fully charge the batteries (page 17).
I fully charged the batteries,
but 7 still flashes.
L
Clean the charge contacts and charge again (page 17).
L
It is time to replace the batteries (page 15).
I fully charged the batteries,
but the operating time seems
to be short.
L
Wipe the battery ends (S, T) and the unit contacts with a dry cloth.
I cannot make calls with the
cordless handset.
L
You dialled a call restricted number. Remove the number from the call
restricted list (page 54).
Problem
Cause & Solution
FC225-226AL-PFQX2518ZA-en.book Page 65 Friday, June 23, 2006 4:08 PM