National Instruments GPIB-ENET/100 User Manual
Page 23
Chapter 3
Ethernet Configuration
© National Instruments Corporation
3-3
•
*Unconfigured* indicates the device is configured to use DHCP,
but DHCP failed to attain network parameters.
•
*Busy* indicates the device is configured to use DHCP and
currently is attempting to acquire network parameters.
Click Properties... for any of the following reasons:
•
You need to configure an unconfigured IP address.
•
You need to change the current network parameters.
•
You previously used DHCP, but it is no longer available.
•
You are using DHCP and need to change the hostname of the
GPIB-ENET/100.
•
The IP address/hostname column displays an exclamation
point (!) next to your GPIB-ENET/100, indicating a configuration
problem. Refer to the
section for help
resolving this problem.
•
You want to add or change a comment to help identify the device.
Click Refresh if you do not see your GPIB-ENET/100 in the list of
Ethernet devices, or to discover a device that you recently added to the
subnet.
Click Exit if you are using DHCP and you do not need to change the
hostname of the GPIB-ENET/100, or if you are finished using the
NI Ethernet Device Configuration utility.