National Instruments GPIB-ENET/100 - Manual (Page 57)

Index
© National Instruments Corporation I-3 GPIB-ENET/100 for Mac OS
I
IBIC 488.2
using, 6-6, B-5
information to record, 2-2
INIT files
managing and renaming, B-3
installation
disabling virus protection, 2-1
Ethernet cable, 2-3
getting started, 1-1
GPIB cable, 5-2
GPIB-ENET/100, 2-2
NI-488.2, 2-1
power cable, 2-3
verification, 5-1
IP address
acquiring automatically using DHCP, 2-5
choosing static IP address, 3-6
defined, 3-6
examples of valid and invalid IP
addresses (table), 3-7
format, 3-6
static IP address, 6-2
using with NI-488 Config, 4-3
IP parameters
DNS server, 3-6
gateway IP, 3-6
if assigned by network administrator, 3-6
if assigned by user, 3-7
IP address, 3-6
subnet mask, 3-6
K
kit contents, 1-1
L
label
example (figure), 2-2
information to record, 2-2
location, 2-2
LabVIEW, 1-5
LEDs
description of each (table), 1-4
overview, 1-3
license
multiple-computer software license, 1-2
N
National Instruments software
LabVIEW, 1-5
National Instruments Web support, D-1
network administrator
assigning IP parameters, 3-6
confirming DHCP availability, 2-4
if DHCP fails, 6-2
network configuration mode
accessing with CFG RESET switch, 6-3
entering automatically, 3-1
when not required, 3-1
when to use, 3-1
network settings
changing, 3-4
configuring with DHCP, 2-5
configuring without DHCP, 2-5, 3-1, 3-5
network specifications, C-2
NI Developer Zone, D-1
NI Ethernet Device Configuration utility.
See Ethernet Device Configuration utility
NI Ethernet Device Firmware utility.
See Ethernet Device Firmware utility