National Instruments GPIB-ENET/100 - Manual (Page 34)

Chapter 5 Verify the Installation
GPIB-ENET/100 for Mac OS 5-2 ni.com
Connecting the GPIB Cable
When you finish verifying the installation, you can connect the GPIB cable
to your GPIB-ENET/100.
Note If you do not have a GPIB cable, as listed in the What You Need to Get Started
section of Chapter 1, Introduction , contact National Instruments for ordering information.
Connect one end of your GPIB cable to your GPIB-ENET/100 and tighten
the thumb screws on the connector. Connect the other end of your GPIB
cable to your GPIB system. Make sure you comply with all IEEE 488.1
cabling restrictions and use only shielded GPIB cables.