Restart your computer, Restart your computer -3 – National Instruments GPIB-ENET/100 User Manual
Page 32
Chapter 4
GPIB Configuration
© National Instruments Corporation
4-3
For more information about NI-488 Config, refer to Chapter 6, GPIB
Configuration Utility, in the NI-488.2 User Manual for MacOS.
Restart Your Computer
Exit NI-488 Config and restart your Macintosh so that the changes you
made in the configuration utility can take effect.
The NI-488.2 driver is installed every time you start or restart your
computer. The National Instruments icon appears momentarily in the
lower left corner of the screen to indicate that the driver is being installed.
If the National Instruments icon does not appear on your screen, repeat
the installation procedure before continuing to the next chapter to verify the
installation and troubleshoot any problems that may occur.