Table e-2, Scxi-1341 and scxi-1344 pin translations – National Instruments SCXI-1163 User Manual
Page 76
SCXI-1163 Cabling
Appendix E
SCXI-1163 User Manual
E-4
© National Instruments Corporation
SCXI-1341 Lab-NB, Lab-PC, or Lab-PC+ and SCXI-1344
Lab-LC Cable Assembly
The SCXI-1341 Lab-NB, Lab-PC, or Lab-PC+ cable assembly connects a Lab-NB, Lab-PC, or
Lab-PC+ board to an SCXI-1163 module. The SCXI-1344 Lab-LC cable assembly connects a
Lab-LC board to an SCXI-1163 module. The SCXI-1341 and SCXI-1344 cable assemblies
consist of two pieces–an adapter board and a 50-conductor ribbon cable that connects the Lab
board to the rear connector of the adapter board. The adapter board converts the signals from the
Lab board I/O connector to a format compatible with the SCXI-1163 rear signal connector pinout
at the front connector of the SCXI-1341 or SCXI-1344. The adapter board also has an additional
male breakout connector that provides the unmodified Lab board signals for use with an
SCXI-1180 feedthrough panel or SCXI-1181 breadboard module. The adapter board gives the
Lab boards full access to the digital control lines. The position of jumper W1 on the SCXI-1341
and SCXI-1344 is irrelevant because the SCXI-1163 does not use jumper W1. Table E-2 lists the
SCXI-1341 and SCXI-1344 pin translations.
Table E-2. SCXI-1341 and SCXI-1344 Pin Translations
Lab Board Pin
Lab Board Signal
SCXI-1163 Pin
SCXI-1163 Signal
1
ACH0
3
No Connect
2
ACH1
5
No Connect
3
ACH2
7
No Connect
4
ACH3
9
No Connect
5
ACH4
11
No Connect
6
ACH5
13
No Connect
7
ACH6
15
No Connect
8
ACH7
17
No Connect
9
AIGND
1-2
No Connect
10
DAC0OUT
20
No Connect
11
AOGND
23
No Connect
12
DAC1OUT
21
No Connect
13, 50
DGND
24
DIG GND
26
PB4
25
SERDATIN
27
PB5
27
DAQD*/A
28
PB6
29
SLOT0SEL*
29
PB7
37
SERCLK
31
PC1
26
SERDATOUT
32
PC2
28
No Connect
40
EXTCONV*
36
No Connect
43
OUTB1
46
No Connect
49
+5 V
34-35
No Connect
All other pins of the Lab board pinout are not sent to the SCXI-1163 rear signal connector.