National Instruments SCXI-1163 - Manual (Page 78)

SCXI-1163 Cabling Appendix E
SCXI-1163 User Manual E-6 © National Instruments Corporation
Table E-3. SCXI-1342 Pin Translations
PC-LPM-16 Pin PC-LPM-16 Signal Rear Signal
Connector Pin
SCXI-1163 Use
1-2 AIGND 1-2 No Connect
3 ACH0 3 No Connect
4 ACH8 4 No Connect
5 ACH1 5 No Connect
6 ACH9 6 No Connect
7 ACH2 7 No Connect
8 ACH10 8 No Connect
9 ACH3 9 No Connect
10 ACH11 10 No Connect
11 ACH4 11 No Connect
12 ACH12 12 No Connect
13 ACH5 13 No Connect
14 ACH13 14 No Connect
15 ACH6 15 No Connect
16 ACH14 16 No Connect
17 ACH7 17 No Connect
18 ACH15 18 No Connect
19, 50 DGND 24 DIG GND
28 DIN6 26 SERDATOUT
29 DIN7 28 No Connect
34 DOUT4 25 SERDATIN
35 DOUT5 27 DAQD*/A
36 DOUT6 29 SLOT0SEL*
37 DOUT7 37 SERCLK
46 OUT2 46 No Connect
49 +5 V 34-35 No Connect
All other pins of the PC-LPM-16 pinout are not sent to the SCXI-1163 rear signal connector.
SCXI-1342 Installation
Follow these steps to install the SCXI-1342:
1. Make sure that the computer and the SCXI chassis are turned off.
2. Install the SCXI module to which the SCXI-1342 will connect.
3. Connect one end of the ribbon cable to the adapter board rear connector.
4. Plug the adapter board front connector onto the module rear signal connector. A corner of
the adapter board will enter the upper board guide of the chassis.
5. Screw the rear panel to the threaded strips in the rear of the chassis.
6. Connect the loose end of the ribbon cable to the PC-LPM-16 I/O connector.