Gpctr1_out signal, Gpctr1_up_down signal, Figure 4-40. gpctr1_out signal timing – National Instruments 6023E User Manual
Page 77: Gpctr1_out signal -47 gpctr1_up_down signal -47, Figure 4-39, Figure 4-40, Gpctr1_out signal timing -47
Chapter 4
Signal Connections
© National Instruments Corporation
4-47
As an output, the GPCTR1_GATE signal monitors the actual gate signal
connected to general-purpose counter 1. This is true even if the gate is
externally generated by another PFI. This output is set to high impedance
at startup.
Figure 4-39 shows the timing requirements for the GPCTR1_GATE signal.
Figure 4-39. GPCTR1_GATE Signal Timing in Edge-Detection Mode
GPCTR1_OUT Signal
This signal is available only as an output on the GPCTR1_OUT pin.
The GPCTR1_OUT signal monitors the TC device general-purpose
counter 1. You have two software-selectable output options—pulse on TC
and toggle output polarity on TC. The output polarity is software-selectable
for both options. This output is set to high impedance at startup.
Figure 4-40 shows the timing requirements for the GPCTR1_OUT signal.
Figure 4-40. GPCTR1_OUT Signal Timing
GPCTR1_UP_DOWN Signal
This signal can be externally input on the DIO7 pin and is not available as
an output on the I/O connector. General-purpose counter 1 counts down
when this pin is at a logic low and counts up at a logic high. This input can
be disabled so that software can control the up-down functionality and
Rising-Edge
Polarity
Falling-Edge
Polarity
t
w
t
w
= 10 ns minimum
GPCTR1_SOURCE
GPCTR1_OUT
GPCTR1_OUT
(Toggle Output on TC)
(Pulse on TC)
TC