National Instruments 700 - Manual (Page 16)

Installation and Configuration Chapter 2
DAQCard-700 User Manual 2-2 © National Instruments Corporation
PCMCIA Socket
Portable
Computer
I/O Cable
INSERT CARD
NA TION AL IN STRUMENT S
The Sof tware is t he Instrument ®
CB-50
I/O Signals
DAQCard
™ -700
Figure 2-1. A Typical Configuration for the DAQCard-700
The DAQCard-700 is now installed. You are ready to make the appropriate connections to the
I/O connector cable as described in Chapter 3, Signal Connections, and to install and configure
your software.
Configuration
The DAQCard-700 is completely software configurable; refer to your software documentation to
install and configure the software.
If you are using NI-DAQ for PC compatibles, refer to the NI-DAQ release notes. Find the
installation and system configuration section for your operating system and follow the
instructions given there.
If you are using NI-DAQ for Macintosh, refer to the NI-DAQ documentation. Find the
installation and system configuration section for your operating system and follow the
instructions given there.
If you are using LabVIEW, the software installation instructions are in your LabVIEW release
notes. After you have installed LabVIEW, refer to the Configuring LabVIEW section of
Chapter 1 of your LabVIEW user manual for software configuration instructions.