National Instruments 700 - Manual (Page 61)

© National Instruments Corporation Index-1 DAQCard-700 User Manual
Index
A
ACH<0..15> signal, 3-3
AIGND signal, 3-3
analog input circuitry
block diagram, 4-4
theory of operation, 4-4
analog input configuration
analog input modes, 2-3 to 2-4
default settings (table), 2-3
DIFF input
definition (table), 2-4
description, 2-4
exceeding maximum ratings
(warning), 2-3
RSE input
definition (table), 2-4
description, 2-4
analog input signal connections
differential (DIFF) connections,
3-8 to 3-11
common-mode signal rejection
considerations, 3-11
floating signal sources, 3-10 to 3-11
grounded signal sources, 3-9
differential input mode, 3-6
exceeding maximum input rating
(warning), 3-4
floating measurement systems, 3-5
floating signal sources, 3-4 to 3-5
ground-referenced measurement
systems, 3-5
ground-referenced signal sources, 3-4
input configurations, 3-5 to 3-6
pins for analog input, 3-4
recommended input configurations, 3-7
single-ended connections, 3-7 to 3-8
single-ended input mode, 3-6
types of measurement systems, 3-5
types of signal sources, 3-4 to 3-5
analog input specifications, A-1 to A-2
B
bus interface for DAQCard-700, A-2
C
cabling, 3-18
Card and Socket Services, C-1
CLK, OUT, and GATE signals for general-
purpose timing, 3-14 to 3-17
CLK1 signal, 3-3
CLK2 signal, 3-3
common-mode signal rejection
considerations, 3-11
configuration. See also installation.
analog I/O
analog input modes, 2-3 to 2-4
default settings (table), 2-3
DIFF input, 2-4
exceeding maximum ratings
(warning), 2-3
RSE input, 2-4
counter/timers, 2-5
digital I/O, 2-5
input configurations, 3-5 to 3-7
differential mode, 3-6
instrumentation amplifier, 3-6
recommended input configurations
(table), 3-7
single-ended mode, 3-6
PCMCIA, C-1
software configuration of
DAQCard-700, 2-2 to 2-3
typical configuration (illustration), 2-2
counter/timers. See also general-purpose
counter and timing connections.
configuration, 2-5
MSM82C54 counter/timer, 3-14 to 3-15
customer communication, xi, E-1
D
DAQCard-700