NETGEAR CVG824G - Manual (Page 15)

Wireless Cable Voice Gateway Model CVG824G Reference Manual
Installing the Gateway 1-3
v1.0, November 2006
The Gateway Rear Panel
The label on the bottom of the gateway identifies the connections on the rear panel. The rear panel
includes the following connections, viewed from left to right, as illustrated in
Figure 1-2 .
• Wireless Antenna: The gateway ships with the wireless antenna already attached.
• Power: AC power adapter input.
• Reset button: Resets the gateway to its factory defaults.
• Four Ethernet LAN ports: Use these ports to connect local computers.
• USB port: If the USB driver is installed, you can connect a local computer to this port.
• Coaxial cable connector: Attach coaxial cable to the cable service provider’s connection.
• Two Voice/Phone ports: With VoIP service, connect one or two handsets to these ports.
Wireless Green Solid The wireless connection is operating normally.
Green Blink Data is being transmitted or received on the wireless interface.
Off No wireless link is detected.
USB Port Green Solid A USB device is connected to the USB port.
Off No USB device is connected.
Voice Ports
(1 and 2)
Green Solid Registered with the Call Agent.
Green Blink There is an active call.
Green Slow
Blink Phone is “on-hook”; registration with Call Agent is in progress.
Off No phones are connected to the voice port.
LAN (Local
Area Network) Green On The Local port has detected link with a 100 Mbps device.
Green Blink Data is being transmitted or received at 100 Mbps.
Amber On The Local port has detected link with a 10 Mbps device.
Amber Blink Data is being transmitted or received at 10 Mbps.
Off No link is detected on this port.
Table 1-1. LED Descriptions (continued)
Label Activity Description