NETGEAR CVG824G - Manual (Page 18)

Wireless Cable Voice Gateway Model CVG824G Reference Manual
1-6 Installing the Gateway
v1.0, November 2006
6. Verify the following:
a. The power light is lit after turning on the gateway.
b. The cable link light is solid green, indicating a link has been established to the cable
network.
c. The LAN LED is lit for the port where you connected the computer.
USB Connection
To connect a computer to the USB port on the gateway.
1. You must install the USB driver. Insert your NETGEAR CD into the CD drive of your
computer.
a. Connect the USB cable to your modem and plug in the AC power for the gateway.
b. Use the USB cable to connect your computer to the gateway.
c. The Found New Hardware Windows installation wizard prompts for the drivers.
d. Browse to the NETGEAR CD and install the USB driver by clicking through the
Windows wizard prompts.
Note: The USB connection option is only available for Windows PCs. Also, Windows 95
does not support USB without special operating system upgrades and patches.