Logging in to the wireless voice gateway, Logging in to the wireless voice gateway -7 – NETGEAR CVG824G User Manual
Page 19
Wireless Cable Voice Gateway Model CVG824G Reference Manual
Installing the Gateway
1-7
v1.0, November 2006
2. Connect your computer to the USB port on the gateway.
3. Plug in your gateway and wait about 30 seconds for the lights to stop blinking.
4. Now, turn on your computer. If software usually logs you in to your Internet connection, do
not run that software or cancel it if it starts automatically.
5. Verify the following:
a. The power light
is lit after turning on the gateway.
b. The cable link light
is solid green, indicating a link has been established to the
cable network.
c.
The USB light
is lit.
Logging In To the Wireless Voice Gateway
To log in to the gateway:
Figure 1-3
Note: To connect to the gateway, your computer must be configured to use DHCP. For
instructions on how to do this, see the link to
“Preparing a Computer for Network
.