NordicTrack None - Manual (Page 10)

8
3. Finger tighten two Top Base Bolts (96) with two 1/2" Star
Washers (124) through the top of the bracket near the
right Upright (93) and into the Base Frame (56); do not
tighten the Top Base Bolts yet.
Repeat this step on the left side of the treadmill.
Then, tighten the Top Base Bolts (96) and the Side Base
Bolts (95) on both sides.
95
93
56
96
124
3
4. Locate the Bolt (B) on the top of each Upright (93). With
the help of a second person, set the console assembly
onto the top of the Uprights. Make sure that the Bolts
are inserted into the indicated holes in the bottom of
the console assembly (only one side is shown). Be
careful not to pinch any wires. Pull up on the Handrail
(103) and carefully tip the console assembly forward so
that you can see the indicated wires. Make sure the con-
sole assembly is held securely by the Bolts.
Connect the wire in the right Upright (93) and the wire in
the console assembly. See the inset drawing. The con-
nectors should slide together easily and snap into
place. If they do not, turn one connector and try again. IF
THE CONNECTORS ARE NOT INSERTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON. If there is a TV Cable,
connect the TV Cable in the console assembly to the TV
Cable in the right Upright. Then, insert the wires down
into the right Upright.
Wires
Hole
93
B
4
Console
Assembly
TV Cables
103
2
2. Slide the Uprights (93) onto the Base Frame (56), and
align the holes in the Uprights with the holes in the Base
Frame. Be careful to avoid pinching the wires. Finger
tighten two Side Base Bolts (95) through the bracket near
the right Upright and into the Base Frame; do not
tighten the Side Base Bolts yet.
Repeat this step on the left side of the treadmill;
there are no wires on the left side.
93
56
95