NordicTrack None - Manual (Page 39)

37
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, see HOW TO CONTACT CUSTOMER CARE on
page 2 of this manual.
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a properly grounded outlet. (See page 12.)
b. Make sure that the key is inserted into the console.
c. Check the on/off circuit breaker located on the treadmill near the power
cord. Make sure that the on/off circuit breaker is switched to the “on” posi-
tion.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the on/off circuit breaker located on the treadmill near the power cord. (See drawing 1. c. above.)
Make sure that the on/off circuit breaker is switched to the “on” position.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key into the console.
d. Check the walking belt and the walking platform for excessive wear. Replace the walking belt or the walking
platform if necessary.
e. If the power still turns off during use, see HOW TO CONTACT CUSTOMER CARE on page 2.
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. If the walking belt is overtightened, performance may
decrease and the walking belt may be damaged. If
the walking belt is properly tightened, you should be
able to lift each side of the walking belt 2.5 to 5 cm (1
to 2 in.) off the walking platform. If adjustments need
to be made, first remove the key and unplug the
power cord. Using a 7/32" hex key, turn both roller
adjustment bolts counterclockwise 1/4 of a turn.
Then, plug in the power cord, insert the key, and use
the treadmill for a few minutes. Be careful to keep the
walking belt centered. Repeat until the walking belt is
properly tightened. Note: To tighten the walking belt,
see step 4. c. on page 38.
b. If the walking belt still slows when walked on, see HOW TO CONTACT CUSTOMER CARE on page 2.
“On”
Position
c
Roller Adjustment Bolts
2.5 to 5 cm
a
T
ROUBLESHOOTING