Navigon MN 6 - Manual (Page 15)

User’s manual MobileNavigator 6
Navigation - 13 -
4.1 Start MobileNavigator 6
1. Switch the navigation device on.
2. Tap on the navigation software symbol.
Each time you start the navigation software , the following
message will appear:
Please note that the road traffic regulations are prior to the
instructions of the navigation system. Please do not
operate the device while driving.
3. After you have read and fully understood the text, tap on
the button OK.
4. If you do not wish to confirm this information then tap on
the Cancel button in order to quit the navigation software.
The Main Window opens. You can reach any of the
navigation software functions via the M
AIN WINDOW
.
4.1.1 Initialising the GPS receiver
Note: It can take up to 20 minutes to initialise the GPS
receiver for the first time.
Each time you switch on the receiver after this, the GPS
reception will start within one minute..
If the navigation device has been switched off for more than a
week, the next initialisation can take up to 10 minutes.
As soon as the navigation device has been switched on,
initialisation of the GPS-receiver will begin.
In the right-hand top corner of the display, you will see the
GPS symbol. As soon as data from at least 3 satellites is
received, the symbol changes to GPS ready.
Note: If the GPS symbol displays GPS ready after
considerably less than 20 minutes, then it is best to switch off
the receiver for at least 15 minutes so as to guarantee reliable
operation of the receiver.
Caution! If you have connected the navigation device to the
power supply using a cigarette lighter, remove the connector
before you leave the vehicle standing for a long period of time.
As the GPS receiver requires a constant power supply, it could
run down the vehicle´s battery.