NCR 7156 - Manual (Page 14)

Chapter 2: Setting Up and Using the Printer 7156 Setup and User’s Guide
September 1998 8
Repacking the Printer
Review the illustrations on the previous two pages to pack the printer.
1.
Place receipt paper between the receipt cover and the printhead for protection.
2.
Remove the ribbon cassette, move the carriage to the right, and place the foam
restraint between the left side of the printer and the carriage to protect the
carriage.
3.
Place the cardboard support on the slip table.
4.
Place the printer in the plastic bag and foam pack, place the packed printer in
the box and secure the box with packing tape.
5.
If you are sending the printer to NCR for repair, call your NCR-authorized
service representative for instructions on where to send the printer.
Be prepared to answer questions concerning shipping and billing.