NCR 7156 - Manual (Page 18)

Chapter 2: Setting Up and Using the Printer 7156 Setup and User’s Guide
September 1998 12
Turning On the Printer
Paper Status
Red LED
On Line
Green LED
Paper Feed Button
On Line Button
with Recessed
Plunger
On Line Button
Paper Status
Red LED
On Line
Green LED
Paper Feed Button
Standard
Operator Panel
Alternate Version
Operator Panel
Note: The operator panel may differ from the standard version (left) depending
on the model. On models matching the alternate version (right), use a paper clip or
pointed object to press the plunger to put the printer on- or off-line.
1.
Press the On Line button (or plunger) to put the printer on-line, if it’s not
already on-line.
The printer goes through a self-test routine to ensure everything is working
properly then “beeps.” The On Line light (green) comes on indicating the
printer is on-line. When the printer has completed its “startup” cycle, it is
ready to receive data.
If the On Line light does not come on, the Paper Out light or the LED on the
slip table flashes, or the host computer indicates that there is a problem, see the
7156 Owner's Guide for more information.
2. Press the On Line button (or plunger) again to put the printer off-line.
Note: The printer receives power when the power supply is on even if the printer
is off-line. To completely remove power, press the On Line button (or plunger) to
put the printer off-line (On Line light is off), then unplug the power supply from
the outlet.