Norton Abrasives C6136 - Manual (Page 17)

17
Item Type Function
12-volt Power Point
Switch Control Activates the 12-volt Power Point
Volt Meter Gauge Displays the charging status of the alternator
Tachometer Gauge Displays the Engine RPM
Oil Pressure Gauge Displays the Engine Oil Pressure in PSI
5. Starting the Engine:
A. Insure that the blade is installed properly
B. Insure that the blade is not touching any object or ground
C. Insure that all Guards are in places and are properly attached to the
machine.
F. Insure that the work area is clear of any hazards
G. Use Approved:
Eye Protection Hearing
Protection
Respiratory
Protection
Head Protection
H. Connect Water supply to Garden Hose Water swivel located on the rear
of the machine
I. Test Water system by opening and closing the water control value
located on the same side as the blade. Water should run out of the
water tubes located in the blade guard. See section: C. Water Supply
on page 18 for more details.
J. Pull the Emergency Kill Switch up to insure that it is not active. If a
problem occurs and it is required to stop or kill the engine press the
Emergency Kill Switch.
K. Turn the Ignition Power Key Switch to the on position
L. Press the START button on the Engine Control Module to crank the
engine. Release the START button when the engine begins to run.