Norton Abrasives C6136 - Manual (Page 37)

37
6. Inspect all Hoses for damage. Replace if damaged. DO NOT use the
machine until any damaged hoses are replaced. Inspect weekly.
7. Inspect all Fittings and Clamps. Insure all Fittings and Clamps are properly
tightened. Inspect weekly.
Dry Cutting Engine Maintenance
9 When operating the engine in dry cutting or dusty environments the following is
required:
9 Engine oil changed more often.
9 Every 50 hours (or more often if conditions require) clean all of the engine
cooling fins.
9 Every 25 hours (or more often if conditions require) clean the engine pre-
cleaner.
9 Every 100 hours (or more often if conditions require) replace the air filter. If the
engine is equipped with a reusable air cleaner, clean and re-oil it.
9 Check and clean the air filter after each use. Replace as needed.
Air Filter C31xx:
The C31xx Classic series Diesel Concrete saw is equipped with a Deutz Dry
Type Air Cleaner.
Location of 31HP Air Filter 31HP Air Filter Components
ITEM DESCRIPTION PART No.
1
AIR FILTER ASSEMBLY TOP 31HP (Includes:
Dust Boot, Filter Element, Housing Top,
Housing Bottom, and Clamp)
237281
2 AIR FILTER ELEMENT 31HP 237282
3 DUST BOOT 237283
Deutz Air
Cleaner 31HP
Only