Norton Abrasives C6136 - Manual (Page 33)

33
Oil Change intervals ‡:
Lube Oil Grade
Deutz Lube Oil Quality Class DQC I DQC II DQC III
ACE Specification E2-96 E3-96/E5-02 E4-99
API Specification CF/CF-4 CG-4/CH-4 -NA-
World Wide Specification -NA- DHD-1 -NA-
Standard Lube Oil code for
building equipment and non-
road vehicles EO
EO A
EO B EO C -NA-
Lube Oil Change Intervals in Operating Hours
Engine Series Engine Version Oil Use Oil Use Oil Use
Engine Type Normal High Normal High Normal High
F3L2011 Turbo 250 125 500 250 500 250
See the Deutz Operation Manual for more information.
Always refer to the engine manual for more detailed information on checking
the oil, changing oil, and oil capacity, and fuel type to use. Use only Deutz Oil
Filters.
Fuel Specifications:
Fuel: Use only commercial grade Diesel fuel rated for on highway use with less
than 0.5% sulfur content. If the sulfur content is greater than 0.5% the oil
change interval will fall in the high use category in the table under Oil Change
Intervals. If the sulfur content is greater than 1% contact a Deutz Service
Center before using. The following fuel specifications are approved by Deutz
Diesel:
DIN EN 590
BS 2569: A1 and A2 (with A2 please note the sulfur content)
ASTM D 975-88; 1-D and 2-D
NATO Code F-54 and F-75
ISO 8217 DMX
ISO 8217 DMA
Bio Diesel Fuel:
According to the DIN 51606 Frame
Exhaust emission values may change dependent on the fuel type. Please
check with local authorities for the type approval test.
For more information see the Deutz Operation Manual or contact your local
Deutz Service Center.