Norton Abrasives C6136 - Manual (Page 23)

23
F. Cutting Technique
The machine is equipped with Depth Gauge and a Depth Stop to help with the
sawing process.
Depth Gauge
The Depth Gauge shows the depth of cut in inches and centimeters. Each time
the blade is changed the Depth Gauge must be reset.
To set the Depth Gauge:
1. Do Not Start the Engine.
2.
Insure that the Water Flow Control valve is off.
3.
Slowly lower the machine with the Raise/Lower Switch by moving it
towards the front of the machine until the blade touches the work
surface.
4.
Rotate the Depth Gauge Indicator to Zero (0)
5.
Raise the Blade off the work surface by moving the Raise/Lower
Switch towards the rear of the machine.
Now the Depth Gauge is reset and will read properly for the blade in stalled on
the machine.
Depth Gauge
Depth Gauge
Indicator
Inch Markings
Centimeter
Markings