Norton Abrasives C6136 - Manual (Page 22)

22
11. Transmission Engage/Disengage lever by fully to the engage position and
slowly push the Forward/Reverse Lever forward until the desired speed is
reached. NOTE: The further the Forward/Reverse Lever is moved the
faster the machine will move in that direction. If the engine begins to stall
or the saw raises out of the cut slow the forward speed down!! The further
the lever is pushed the fast the saw will move.
12. When the end of the cut is reached, raise the blade out of the cut by moving
the Raise/Lower Switch to the rear of the machine until the blade is at least
one (1) inch above the ground.
13. To use reverse, move the saw move the Speed Control lever to the rear of
the saw. Only move the saw in reverse with the blade in the raise position.
Always place the speed control back in the neutral position after moving
the saw.
14. When moving the saw to a new location be sure that the blade is not
touching the ground and always pay close attention to where you are
moving and where the blade is at all times.
14. When the next cut is reached, align the saw with the cut and lower the
blade into the concrete. Push the control lever forward until the lever aligns
with the same location used to make the previous cut.
15. To disengage the transmission, place the Speed Control in the Neutral
position and then slide the Transmission Engage/Disengage lever by fully
to the “Disengage” position.
Caution: Do Not Engage Or Disengage The
Transmission While The Machine Is In The
Forward Or Reverse Positions!