Nortel Networks Server 600r - Manual (Page 19)

Supported peripheral devices 19
For information about how to identify the location of the network interface
connectors, see
"Rear panel controls and features" (page 15) .
Network requirements
Appropriate networking equipment must be available for the ELAN subnet
and the optional Nortel server subnet, if it is used.
The ELAN subnet (and the optional Nortel server subnet, if used) must
be properly configured for correct CallPilot operation. To ensure correct
configuration, Nortel recommends that you consult a network specialist.
Remote access connectivity
Use the USB connection on the rear of the 600r server to connect to an
external dial-up modem. With the modem, administrators and technical
support personnel can administer the 600r server from a remote location.
You can also access the 600r server from a remote location directly over the
network, without the use of a modem.
Supported peripheral devices
This section identifies external devices that are supported by the 600r
server.
Table 3
Supported peripheral devices
Device Description
Modem Use a 56 Kb/s external modem to provide remote access to the 600r server.
The modem connects to a USB connector (USB 2, the top connector) on
the rear of the server.
Ethernet switch or
hub A 10Base-T compliant Ethernet switch or hub provides the ELAN connection
between the 600r server and the Meridian 1 switch or CS 1000 system. The
customer can supply a Ethernet switch or hub from third-party vendors or from
Nortel. Because the Ethernet switch or hub is an external device, the Ethernet
switch or hub requires an AC power source.
Monitor, keyboard,
and mouse • Monitor: (customer supplied). Because the monitor is an external device,
it requires its own AC power source.
• Keyboard: (customer supplied)
• Mouse: (customer supplied)
External tape drive Tandberg SLR75 (optional)
Nortel software
feature dongle The software feature dongle or key is a security device that stores the unique
serial number of the server. The dongle plugs into a USB connector (USB 0,
the bottom connector) on the rear panel.
Nortel CallPilot
600r Server Hardware Installation
NN44200-307 01.03 Standard
5.0 14 May 2008
Copyright © 2007-2008, Nortel Networks
.