Nortel Networks Server 600r - Manual (Page 30)

30 Chapter 4 Installing the server and peripheral devices
To connect the modem to the server
You require a modem to support remote dial-up access to the CallPilot
server. With a modem, Nortel technical support can connect to your
CallPilot server for troubleshooting purposes. Nortel connects to your server
only when you request technical assistance.
Windows automatically recognizes your modem after you connect it and
power it on. The power light (PWR LED) does not illuminate until the
Windows device driver successfully loads and recognizes the hardware.
To install the modem, you need the following equipment:
• USB modem
• RJ-11 analog phone cord
• USB cable (supplied with the modem)
• an analog line jack
Serial port modems with RS-232 connections are not supported on the 600r.
Step Action
1 Connect one end of the USB cable into the modem.
2 Connect the other end of the USB cable into USB 2 on the rear panel.
3 Connect one end of the telephone cable to the modem RJ-11 jack
labeled LINE.
4 Connect the other end of the telephone cable to the RJ-11 jack in
the wall.
—End—
To connect the external SCSI tape drive
When you connect an external SCSI tape drive, the device must be
terminated. Your tape drive comes with a terminator. (See Tape drive
terminator in
Figure 8 "SCSI tape drive with terminator" (page 31) .) The
600r server also comes with a server terminator, a VHDCI (Very High
Density Connection Interface) Ultra320 SCSI terminator. (See Server
terminator in
Figure 8 "SCSI tape drive with terminator" (page 31) .) In a
previous procedure, you are instructed to connect the server terminator to
the SCSI port. Before you connect an external tape drive to the 600r, you
must remove the server terminator.
Note: If you do not connect a SCSI device to the server, do not remove
the server terminator from the SCSI port.
Nortel CallPilot
600r Server Hardware Installation
NN44200-307 01.03 Standard
5.0 14 May 2008
Copyright © 2007-2008, Nortel Networks
.