NetComm V110 - Manual (Page 26)

�11��� ��1���� ��11�� ���� User Guide YML881Rev1
� www.netcomm.com.au
User name Your VoIP number. This number is assigned by your VoIP service provider.
Auth name The authentication username assigned by your VoIP service provider. This can be
different to your VoIP number.
Auth Password The authentication password provided by your VoIP service provider.
Subscribe for mWI When enabled the Subscribe for Message Waiting Indication will be sent periodically.
Status
Indicates if the VoIP Gateway is registered to your VSP. If “Registered” is shown, you can
make and receive calls via your VoIP service provider. If the VoIP gateway reports “not
registered”, check the SIP Service Provider settings above and try again.
SIP expiry time This setting specifies a recommendation to the SIP server on the re-registration interval.
Increasing this time will send less registration traffic, but can cause other issues.
Use dnS SrV When DNS SRV is switched on, the VoIP Gateway will look up DNS SRV records and
register with the server with the highest priority. DNS SRV can provide redundancy if the
primary SIP server becomes unreachable. Please check with your VSP to find out if they
support DNS SRV.
Port Setting
You can configure the SIP and RTP port number in this page. Please leave as default unless otherwise
specified by your VSP.
options description
SIP Port The port on the SIP server that receives requests from the ATA. Default: 5060.
rtP Port The base port to receive RTP packets. Default: 60000.