Hardware installation – NetComm V110 User Manual
Page 9
YML881Rev1
�11��� ��1���� ��11�� ����
�11��� ��1���� ��11�� ����
User Guide
www.netcomm.com.au
hArdWAre InStAllAtIon
1.
Connect the WAN port to your broadband router using the Ethernet cable supplied. If you would like
your PC to be connected to the network through the V100/V210P/V211/V220, you can connect another
Ethernet cable (not supplied) from your PC to the LAN Ethernet port. This enables your PC and the ATA to
share one Ethernet port on your router/switch.
��11 and ��1��
2.
Connect your telephone handset to the Phone port. For V220, you can connect an additional handset to
Phone 2 port.
Notes: A second �oI� account is needed unless your �oI� provider supports multiple connections from the one account and both ports
need to be configured individually (even when using one account that supports multiple connections).
3.
For V210P or V211 unit, connect the Line port to your PSTN wall socket.
4.
Connect the AC power adaptor and press the power button to turn the ATA on. The ATA will boot up and in
a few minutes, the Power and Ethernet Lights will light up.
Note: Only use the power adapter supplied with the NetComm ATA. A different adapter may damage the product.