NetComm V110 - Manual (Page 8)

�11��� ��1���� ��11�� ���� User Guide YML881Rev1
8 www.netcomm.com.au
default Settings
lAn (management)
Static IP Address: 192.168.22.1
Subnet mask: 255.255.255.0
default Gateway: blank
WAn (Internet)
WAn mode: DHCP
modem Access
Username: admin
Password: admin
Many configuration changes made using the web interface will only become active after clicking the Save &
Reboot button on the Save Savings / Reboot page in the web configuration page.
note: certain voice parameters do not require a Save & reboot to take effect. these Voice Parameters will take effect on the next voice
call after the Voice Parameter is entered and submitted. however, if Save & reboot is not done, then these Voice Parameters will not be
saved over a power cycle. the Voice Parameters that can be changed “on the fly” are noted in the respective sections.
restoring factory defaults
The reset button will reset the ATA to its factory default configuration. Occasions may present themselves
where you need to restore the factory default settings on your ATA. Typical situations are:
• You have lost your password and unable to login to the ATA;
• You have purchased the router from someone else and need to reconfigure the device.
• You are asked to perform a factory reset by a member of the excellent NetComm Support Staff.
In order to restore your router to its factory default settings, please follow these
steps:
• Ensure that the ATA is powered on (for at least 20 seconds).
• Use a paper clip or a pencil tip to depress the reset button for ten seconds and release. At this point, the
reset is in progress. Do not power off the unit at this point.
• After the ATA reboots, the default settings are now restored. This entire process takes several minutes to
complete.
• Once you have reset the ATA to its default settings you will be able to access the device’s web
configuration using http://192.168.22.1 with username “admin” and password “admin”.